>
Check the latest news shared with the press:
See all Industry News Company News
Submersible Motors vs Ordinary Motors
As a special motorcapable of prolonged underwater operation, submersible motors require designand performance adaptations to complex aquatic environments, resulting inseveral distinct characteristics: 1. SealingPerformanceCore requirement: Prevent water i
Are All High-Voltage Motors Prone to Partial Discharge?
Critical Insights on Voltage, Air Gaps, and Insulation Design to Prevent Winding Failures.
How can bearing radial clearance and alignment be optimized to ensure motor performance?
Proper control of radial clearance and positioning directly impacts motor efficiency, noise levels, and lifespan.
Why Do Motor Bearing Failures Often Occur at the Non-Drive End?
Motor bearings are critical components in industrial equipment, yet failures frequently occur at the non-drive end (NDE).
Submersible Motors-Unique Challenges and Engineering Solutions
Submersible motors, critical components in pumps for wastewater management, oil extraction, and marine applications, face extreme operational environments.
Upgraded VHS IP55 Motor Frame
We upgraded the Vertical Hollow Shaft Motor IP55 frame for achieve better cooling effect.
Customized design IC81W Cooling Method Vertical Octagonal High-Voltage Motor
IC81W Coolling Method Vertical Octagonal High Voltage Motor for Pump
How to Selecting a Low or Medium-Voltage Electric Motor?
The big question in motor selection:low-voltage or medium-voltage
Why is high voltage and medium voltage preferred for high power motor?
Why high output motor is suitable for high voltage and medium voltage?
Difference Between Vertical Hollow Shaft and Vertical Solid Shaft Motors
What Differences Between Vertical Hollow Shaft (VHS) Pump Motors and Vertical Solid Shaft (VSS) Motors?
Stainless Steel TC and TD flange for NEMA Motor
NEMA motor TC and TD flange
What causes a short circuit in the slip ring of a slip ring induction motor?How to slove it?
The flash over in the slip ring is a typical problem that occurs with slip ring motors.Our company design a manual/automatic blowing control device.